How to set up a visual CCD laser cutting machine? Accurately identify the outline of the image and quickly cut the printed fabric. Realize automatic, precise and fast cutting of printed garments.
First step Camera focus adjustment
As shown below (Remarks; AF/MF is built to focus ON/OFF for anti-shake)
Adjust the two switches to AF and ON respectively and place a piece of colored material under the camera as shown below.
Click on punctuation management as shown below
After entering the calibration management, click to get the grid point. At this time, the camera will take the photo as shown below (Remarks; click to get the grid point to take the photo. There is no calibration file in the software or the calibration file can not be used. If there is a calibration file, just refocusing is directly
We observe whether the graphics in the photos are clear. If it is not clear, we can click on the grid and then the camera will take a photo again until the graphics are clear. When the graphics are clear, as shown below.
We will set up the AF/MF to the MF seat.
Open the Ever cutting SCCD software and click on the parameter settings as shown below.
Then click on the query system to automatically read the machine format and then set the machine origin as shown below
After setting, put a piece of white paper under the camera (the size of the white paper is slightly larger than the grid line width, do not move the paper when the entire calibration process is not completed) as shown below.
Click on the calibration management to set the grid line range (remarks; the spacing should be 50 or 100, so the calibration range should be a multiple of 50 or 100) as shown below.
After finishing the grid line, click to get the grid point as shown below.
As shown in the above figure, there are extra cross points and points that are not at the intersection of the cut lines. Click on the delete point frame to select the extra cross points to delete. In the figure, the intersection of the cut lines has no cross points. Click on the acquisition point to move the mouse to the intersection of the cut lines. Double click the mouse.
Delete point Click on the calibration after adding the point
Please restart the software after the calibration is completed.
Click to take a photo after restarting the software
Re-photographed in the picture, draw nine circles or squares, click on the common cut as shown below.