As the core component of the laser machine, the small bearings and the shafts on the laser slider need to be cleaned and maintained every day. If you do not pay attention to the cutting residue stuck on the surface, it will cause serious problems such as severe rusting of the bearing and the optical axis, cutting and jamming, lost steps, bearing deformation, and deformation of the cutting pattern.
How to maintain:
The cleaning work begins before the machine is turned on. Wipe the optical axis and the bearing with a clean cloth to remove oil traces, dust and debris. Please note that the optical axis and bearings in the work must not have oil, otherwise it will easily adhere to the dust and cause the pulley bearing to jam;
The cleaning work begins after the machine has been shut down. Wipe the shaft and bearings with a clean cloth to remove dust and debris. Then, according to the actual situation, wipe the machine with a little sewing machine oil and lubricate the machine. Can be once a week. Please do not drop the oil directly, otherwise the excess oil will leak, and after dropping onto the machine table, it will cause aging effects on the lines inside the machine chain.
The laser machine has two symmetrical shafts on each of the guide rails, and all need to be in place.
In short, the cleaning work needs to be done every day, but the oil lubrication can be carried out once every ten days and a half.